janome_1008_disassembly
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
janome_1008_disassembly [2023/06/05 02:27] – stephen | janome_1008_disassembly [2023/06/06 05:22] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 12: | Line 12: | ||
| B7 | Bottom side, arm section, middle | Short | Rear panel removal | | | | B7 | Bottom side, arm section, middle | Short | Rear panel removal | | | ||
| R1 | Right side, middle | Screw with plastic cover | Front & rear panel removal | Remove plastic cover with flathead from right side. | | | R1 | Right side, middle | Screw with plastic cover | Front & rear panel removal | Remove plastic cover with flathead from right side. | | ||
- | + | | BK1 | Back side, middle | | Front & rear panel removal | | | |
+ | | L0 | Left side, top arm, middle | | Front panel removal | | | ||
+ | | L1 | Left side, inside top arm, top | Hat | Front panel removal | //Not// the screw that goes into the purple tensioner. Loosen only. | | ||
+ | | L2 | Left side, inside top arm, bottom | | Front panel removal | The //big// screw above the smaller screw. | | ||
+ | | T1 | Top side, below right side of handle | Screw with metal tab | ??? Front panel removal ??? | Removal may not be required. | | ||
+ | | F1 | Front side, inside bobbin cover, bottom right | Hat | Front panel removal | | | ||
===== Bottom ===== | ===== Bottom ===== | ||
Line 19: | Line 23: | ||
{{: | {{: | ||
{{: | {{: | ||
+ | |||
+ | ===== Right ===== | ||
+ | |||
+ | No need to remove the purple turnie thing. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ===== Back ===== | ||
+ | |||
+ | {{: | ||
+ | |||
+ | ===== Left ===== | ||
+ | |||
+ | There is no need to remove the purple tensioner. | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | ===== Top ===== | ||
+ | |||
+ | One screw only is required to be removed, and I'm not sure even that needs to be removed. | ||
+ | |||
+ | {{:: | ||
+ | |||
+ | ===== Front ===== | ||
+ | |||
+ | Selector and Length knobs - pull straight out. | ||
+ | |||
+ | Bobbin cover - open fully, lift left side out and slightly up. | ||
+ | |||
+ | {{:: | ||
+ | {{: | ||
+ |
janome_1008_disassembly.1685932044.txt.gz · Last modified: 2023/06/06 03:27 (external edit)