janome_1008_disassembly
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| janome_1008_disassembly [2023/06/05 01:24] – created stephen | janome_1008_disassembly [2023/06/06 05:22] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| | B6 | Internal, access from bottom side, middle left | Hat | Front panel removal | Loosen only | | | B6 | Internal, access from bottom side, middle left | Hat | Front panel removal | Loosen only | | ||
| | B7 | Bottom side, arm section, middle | Short | Rear panel removal | | | | B7 | Bottom side, arm section, middle | Short | Rear panel removal | | | ||
| + | | R1 | Right side, middle | Screw with plastic cover | Front & rear panel removal | Remove plastic cover with flathead from right side. | | ||
| + | | BK1 | Back side, middle | | Front & rear panel removal | | | ||
| + | | L0 | Left side, top arm, middle | | Front panel removal | | | ||
| + | | L1 | Left side, inside top arm, top | Hat | Front panel removal | //Not// the screw that goes into the purple tensioner. Loosen only. | | ||
| + | | L2 | Left side, inside top arm, bottom | | Front panel removal | The //big// screw above the smaller screw. | | ||
| + | | T1 | Top side, below right side of handle | Screw with metal tab | ??? Front panel removal ??? | Removal may not be required. | | ||
| + | | F1 | Front side, inside bobbin cover, bottom right | Hat | Front panel removal | | | ||
| + | ===== Bottom ===== | ||
| + | {{: | ||
| + | {{: | ||
| + | |||
| + | ===== Right ===== | ||
| + | |||
| + | No need to remove the purple turnie thing. | ||
| + | |||
| + | {{: | ||
| + | |||
| + | ===== Back ===== | ||
| + | |||
| + | {{: | ||
| + | |||
| + | ===== Left ===== | ||
| + | |||
| + | There is no need to remove the purple tensioner. | ||
| + | |||
| + | {{: | ||
| + | {{: | ||
| + | |||
| + | ===== Top ===== | ||
| + | |||
| + | One screw only is required to be removed, and I'm not sure even that needs to be removed. | ||
| + | |||
| + | {{:: | ||
| + | |||
| + | ===== Front ===== | ||
| + | |||
| + | Selector and Length knobs - pull straight out. | ||
| + | |||
| + | Bobbin cover - open fully, lift left side out and slightly up. | ||
| + | |||
| + | {{:: | ||
| + | {{: | ||
janome_1008_disassembly.1685928240.txt.gz · Last modified: 2023/06/06 02:24 (external edit)
