====== Janome 1008 Disassembly ======

===== Screws =====

^ Screw ^ Location ^ Type ^ For ^ Notes ^
| B1 | Bottom side, top left | Hat | Front panel removal | |
| B2 | Bottom side, bottom left | | Front panel removal | |
| B3 | Bottom side, top right | | Front panel removal | |
| B4 | Bottom side, bottom right | | Front panel removal | |
| B5 | Bottom side, middle right | Hat | Front panel removal | |
| B6 | Internal, access from bottom side, middle left | Hat | Front panel removal | Loosen only |
| B7 | Bottom side, arm section, middle | Short | Rear panel removal | |
| R1 | Right side, middle | Screw with plastic cover | Front & rear panel removal | Remove plastic cover with flathead from right side. |
| BK1 | Back side, middle | | Front & rear panel removal | |
| L0 | Left side, top arm, middle | | Front panel removal | |
| L1 | Left side, inside top arm, top | Hat | Front panel removal | //Not// the screw that goes into the purple tensioner. Loosen only. |
| L2 | Left side, inside top arm, bottom | | Front panel removal | The //big// screw above the smaller screw. |
| T1 | Top side, below right side of handle | Screw with metal tab | ??? Front panel removal ??? | Removal may not be required. |
| F1 | Front side, inside bobbin cover, bottom right | Hat | Front panel removal | |

===== Bottom =====

{{:janome_1008_front_cover_off_hidden_screw.jpg?direct&400 |}}
{{:janome_1008_bottom_screw_locations.jpg?direct&400 |}}

===== Right =====

No need to remove the purple turnie thing.

{{:janome_1008_right_top_section_screw_locations.jpg?direct&400 |}}

===== Back =====

{{:janome_1008_back_screw_locations.jpg?direct&400 |}}

===== Left =====

There is no need to remove the purple tensioner.

{{:janome_1008_left_top_arm_screw_locations.jpg?direct&400 |}}
{{:janome_1008_left_top_arm_cover_off_screw_locations.jpg?direct&400 |}}

===== Top =====

One screw only is required to be removed, and I'm not sure even that needs to be removed.

{{::janome_1008_top_screw_locations.jpg?direct&400 |}}

===== Front =====

Selector and Length knobs - pull straight out.

Bobbin cover - open fully, lift left side out and slightly up.

{{::janome_1008_front_bobbin_section_cover_and_screw_locations.jpg?direct&400 |}}
{{:janome_1008_front_screw_locations.jpg?direct&400 |}}