Stephen's Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Petrol Line Trimmer ======

===== Specifications =====

  * Flash Brush Cutter Lightweight 32CC, BCLIGHT32
  * Engine: 32.6cc 2-stroke single cylinder air cooled
  * Maximum engine output: 0.8kW
  * Spark plug: NGK
  * Shaft diameter: 26mm
  * Brush cutter blade cutting diameter: 255mm
  * Nylon cutter cutting diameter: 415mm
  * Two-cycle oil and petrol mixing ratio: 1:25 (Petrol 25, two-stroke oil 1)
  * Overall dimensions: 184 x 57 x 50cm
  * Weight: 7kg
  * Line squasher screw: M10, 20mm, countersunk head, hex socket screw

Alternative Trimmer Head

  * Max line diameter: 3.5mm
  * Line length: 26cm

===== Start Procedure =====

Note 1: Trimmer will not start with choke on (up).\\
Note 2: Turn choke off (down) as soon as it starts.

  - Switch on handle to '1'.
  - Choke on full (up).
  - Pull on starter, 3 or 4 times or until it splutters.
  - Choke on half.
  - Pull on starter, 3 or 4 times or until it starts.
  - Choke off (down).
  - Pull on starter.
  - If it won't start, try opening the throttle.

===== Head Disassembly =====

{{ :20241229_line_trimmer_head.jpg?400 |}}

  - Remove the Line Squisher Screw with Allen key - standard thread.
  - Remove the line.
  - Insert a grunty screwdriver through line holes in part A.
  - Use vice grips with inner tube on part B.
  - Unscrew part A from part B - **reverse** thread.
  - Remove part A.
  - Insert Allen key through the hole in cap, through part C, and into the bit inside to prevent part C from turning. 
  - Unscrew locking nut inside part B - **reverse** thread.
  - Remove locking nut and washer.