petrol_line_trimmer
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| petrol_line_trimmer [2023/01/18 23:21] – created stephen | petrol_line_trimmer [2025/02/07 02:16] (current) – stephen | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| * Overall dimensions: 184 x 57 x 50cm | * Overall dimensions: 184 x 57 x 50cm | ||
| * Weight: 7kg | * Weight: 7kg | ||
| + | * Line squasher screw: M10, 20mm, countersunk head, hex socket screw | ||
| Alternative Trimmer Head | Alternative Trimmer Head | ||
| Line 21: | Line 22: | ||
| ===== Start Procedure ===== | ===== Start Procedure ===== | ||
| - | Note 1: Trimmer will not start with choke on (up). | + | Note 1: Trimmer will not start with choke on (up).\\ |
| Note 2: Turn choke off (down) as soon as it starts. | Note 2: Turn choke off (down) as soon as it starts. | ||
| Line 29: | Line 30: | ||
| - Choke on half. | - Choke on half. | ||
| - Pull on starter, 3 or 4 times or until it starts. | - Pull on starter, 3 or 4 times or until it starts. | ||
| - | - Choke off. | + | - Choke off (down). |
| - Pull on starter. | - Pull on starter. | ||
| - If it won't start, try opening the throttle. | - If it won't start, try opening the throttle. | ||
| + | |||
| + | ===== Head Disassembly ===== | ||
| + | |||
| + | {{ : | ||
| + | |||
| + | - Remove the Line Squisher Screw with Allen key - standard thread. | ||
| + | - Remove the line. | ||
| + | - Insert a grunty screwdriver through line holes in part A. | ||
| + | - Use vice grips with inner tube on part B. | ||
| + | - Unscrew part A from part B - **reverse** thread. | ||
| + | - Remove part A. | ||
| + | - Insert Allen key through the hole in cap, through part C, and into the bit inside to prevent part C from turning. | ||
| + | - Unscrew locking nut inside part B - **reverse** thread. | ||
| + | - Remove locking nut and washer. | ||
petrol_line_trimmer.1674084094.txt.gz · Last modified: 2023/01/20 00:21 (external edit)